Gaggenau Appliance Error Codes

Gaggenau Range & Stove Error Codes

• E011 – Control Panel Locked: The stove’s control surface is locked and requires manual unlocking.
• E115 – Overheating Sensor Triggered: Temperature sensor detected dangerously high internal heat.
• E212 – Cooling Fan Failure: Internal fan is not providing proper airflow, risking overheating.
• E305 – Internal Communication Fault: Control boards are not communicating properly.
• E512 – Power Module Failure: Electrical control components are malfunctioning.
• E701 – Heating Element Malfunction: A main heating element is not functioning correctly.

Gaggenau Oven Error Codes

• E010 – Touch Panel Locked: Oven controls are locked and not responding.
• E115 – Sensor Overheat Detected: Internal temperature above safe limits.
• E118 – Sensor Too Cold: Temperature sensor reading is abnormally low.
• E320 – Communication Fault: Oven boards cannot sync correctly.
• E512 – PCB Failure: Main electronic board is malfunctioning.
• E601 – Cooling Fan Error: Fan cannot circulate air, disrupting temperature regulation.

Gaggenau Cooktop Error Codes

• E0 – No Cookware Detected: Induction zone does not detect compatible cookware.
• E2 – Cooktop Overheating: Induction zone overheated and shut down.
• E5 – Electronics Overheated: Internal components are too hot to function.
• E9 – Temperature Sensor Fault: Sensor readings are incorrect.
• ER22 – Touch Panel Failure: Touch controls blocked or unresponsive.
• F0 – Power Supply Issue: Insufficient or unstable voltage detected.

Gaggenau Ventilation Hood Error Codes

• E2 – Fan Motor Error: The fan cannot start or maintain correct speed.
• E4 – Temperature Sensor Fault: Incorrect hood temperature readings.
• E5 – Lighting Circuit Error: Hood lights malfunctioning.
• E7 – Control Panel Error: Buttons or panel communication failure.
• E10 – Power Module Issue: Electrical power supply irregularity detected.
• E20 – Filter Detection Error: Hood cannot register installed filters correctly.

Gaggenau Refrigerator Error Codes

• E01 – Control Board Fault: Electronic malfunction affecting cooling performance.
• E02 – Freezer Sensor Fault: Temperature readings in freezer are incorrect.
• E03 – Refrigerator Sensor Error: Fresh food compartment sensor malfunction.
• E10 – Defrost Heater Error: Defrost cycle cannot operate properly.
• E20 – Evaporator Fan Fault: Fan not spinning or weak airflow.
• E90 – Voltage Irregularity: Unsafe voltage detected, forcing slowdown.

Gaggenau Dishwasher Error Codes

• E09 – Heating Element Fault: Water cannot reach proper temperature.
• E15 – Leak Protection Activated: Water detected in base pan; system shut down.
• E16 – Inlet Water Error: Not enough water entering the system.
• E17 – Overfill Error: Excess water detected inside appliance.
• E24 – Drainage Fault: Water is not draining correctly.
• E25 – Pump Blockage: Drain pump obstructed by debris.

Gaggenau Warming Drawer Error Codes

• E1 – Temperature Sensor Failure: Drawer temperature cannot be measured correctly.
• E4 – Heating System Failure: Heating element or thermostat malfunction.
• E7 – Communication Error: Drawer control board is not communicating.
• E10 – Overheating: Drawer overheated and shut down to protect electronics.
• E19 – Power Fault: Voltage or PCB power irregularity detected.
• E32 – Mechanism Jam: Drawer glide or motor obstructed.