Microwave repair in New York

For countertop units, yes, buy new. But for built-in or drawer microwaves (like Wolf, Thermador, or Bosch), repair is the only logical choice. These units are sized to fit specific cabinetry cutouts. Replacing them often costs $2,000+ and requires a carpenter to modify the trim kit. Repairing a door switch or a magnetron is a fraction of that cost and preserves your kitchen's aesthetic.

It is the most common cause. The Magnetron generates the waves. If it fails (or if the high-voltage diode shorts out), the light turns on and the plate spins, but no heat is produced. We can safely discharge the high-voltage capacitor and replace the magnetron to restore full power.

This is called Arcing. It’s usually caused by exposed metal (gold-rimmed plates), a burnt waveguide cover, or food splatter carbonizing on the walls. It looks scary but is rarely catastrophic. We replace the mica waveguide cover and inspect the interior paint to ensure it’s safe to use again.

This is typically a failure in the Door Switch Interlock system. For safety, microwaves have 3-4 switches to confirm the door is sealed. If even one is slightly misaligned or worn, the computer kills the power instantly to prevent radiation leakage. We align and replace these switches regularly.

Yes. Drawer microwaves rely on a belt-driven motor or a rail system. If the rails get gummed up with crumbs or the belt stretches, the drawer jams. We disassemble the slide mechanism, clean the tracks, and replace the drive belt so it glides smoothly again.